'27 T-Bucket

The '27 T-Bucket before.

The Heidts IRS rear end is shipped in pieces and must be assembled.

The first step is to install the axle seals and studs to bolt in the stub axles.

After that the third member can be installed, and then the stub axles.

The front pinion plate is installed onto the pinion assembly using the bolt that holds the pinion assembly to the third member.

Next we begin to install the control arms.

Here the brake rotors and half shafts have been installed.

Next are the outer uprights, and bearings which the half shaft will ride in.

The last thing to be installed onto the new rear end is the top crossmember, which will provide a mounting point to the frame.